How Many Questions Of 220-1101 Free Draindumps

NEW QUESTION 1
Which of the following would MOST likely be used to obtain electronic images of a large number of printed documents?

• A. NFC device
• B. ADF/flatbed scanner
• C. Camera/webcam
• D. QR scanner

Answer: B

NEW QUESTION 2
A technician is tasked with installing additional RAM in a desktop computer. Which of the following types of RAM is MOST likely to be used?

• A. SODIMM
• B. DDR3
• C. ECC
• D. VRAM

Answer: B

NEW QUESTION 3
Which of the following network devices is used to separate broadcast domains?

• A. Switch
• B. Wireless access point
• C. Router
• D. Hub

Answer: A

NEW QUESTION 4
Several users who share a multifunction printer in an office have reported unintended, thin, vertical lines that cover the entire height of every page printed from the printer. Which of the following steps should a technician complete in order to
MOST likely resolve this issue?

• A. Replace the printer paper with a new ream.
• B. Clear the print spooler on each computer.
• C. Reinstall the printer driver on each computer
• D. Perform the drum-cleaning procedure.

Answer: D

NEW QUESTION 5
A technician is upgrading a faulty motherboard that was ordered by an end user for an old, high-end desktop computer. However, the technician is unable to install the CPU into the socket. Upon closer inspection, the technician notices the pins on the CPU do not line up with the socket. Which of the following would be the best course of action for the technician to take NEXT?

• A. Try to set as many pins as possible.
• B. Install an adaptor to create a universal socket.
• C. Verify the socket type and manufacturer.
• D. Find a compatible motherboard for the CPU.

Answer: D

NEW QUESTION 6
A user brings an older laptop to the help desk and reports issues with the keyboard. Upon inspection, the technician does not see any external damage but notices that many keystrokes da not register in a word processor. The laptop works fine when the technician tests it with an external keyboard. Which of the following actions would MOST likely resolve the issue?

• A. Disable the sticky keys feature.
• B. Clean the keyboard.
• C. Reset the BIOS settings to default.
• D. Charge the laptop.

Answer: C

NEW QUESTION 7
A technician needs to add storage to a workstation. The workstation does not have room to add any internal storage, so the technician plans to add an external storage device. Which of the following connection types should the technician MOST likely use?

• A. SCSI
• B. eSATA
• C. PCIe
• D. NVMe

Answer: B

NEW QUESTION 8
A technician installed a Cat 5 UTP cable approximately 275ft (84m) from a network switch in an office to a workstation located on a factory floor The technician sees both a flashing green LED and a flashing orange LED on the workstation's NIC. Which of the following should the technician do FIRST?

• A. Check for loose connections, pinched bends, and physical damage.
• B. Install a powered hub as close as possible to the halfway point in the Cat 5 UTP cable run.
• C. Replace the entire run of Cat 5 UTP cable with Cat 5 STP cable.
• D. Upgrade the entire cable run to multimode fiber.

Answer: A

NEW QUESTION 9
A technician powers on a PC and its monitor and sees the following error message:
No input signal detected
The display lights on the computer are on. Which of the following is a possible solution?

• A. Changing the BIOS settings
• B. Changing the connector setting on the monitor
• C. Checking the power plug on the monitor
• D. Checking the power plug on the PC

Answer: B

NEW QUESTION 10
A technician installed a Cat 5 UTP cable approximately 275ft (84m) from a network switch in an office to a workstation located on a factory floor The technician sees both a flashing green LED and a flashing orange LED on the workstation's NIC. Which of the following should the technician do FIRST?

• A. Check for loose connections, pinched bends, and physical damage.
• B. Install a powered hub as close as possible to the halfway point in the Cat 5 UTP cable run.
• C. Replace the entire run of Cat 5 UTP cable with Cat 5 STP cable.
• D. Upgrade the entire cable run to multimode fiber.

Answer: A

NEW QUESTION 11
A laptop PC user is reporting issues with the hard drive. A filesystem check shows that all files are accessible and the filesystem is clean. After the check, the PC still issues a hard drive error message. Which of the following is the MOST likely cause of the error?

• A. S.M.A.R.T failure
• B. IOPS failure
• C. DIMM failure
• D. RAID failure

Answer: A

NEW QUESTION 12
A technician needs to recommend an internet connection for a customer who travels around the world and wants to have connectivity while visiting remote camping locations. Some of the locations the customer visits have limited or unreliable cellular service. Which of the following connection types should the technician recommend?

• A. Satellite
• B. DSL
• C. Fiber
• D. Hotspot

Answer: A

NEW QUESTION 13
A laptop has been returned for a screen repair. The owner insists the screen is broken, but occasionally a faded image is able to be seen in very bright settings on the desktop. Which of the following steps should the repair technician take FIRST?

• A. Replace the graphics card.
• B. Replace the screen, as the customer insists.
• C. Recommend the usage of an external display instead.
• D. Ensure the backlight is functioning as expected.

Answer: D

NEW QUESTION 14
A customer reports that a computer is never able to reach more than a 100Mbps transfer data rate, even when using a Gigabit LAN card. While troubleshooting, the technician notices the network cable needs to be replaced. Which of the following cable categories is limiting the transfer speed?

• A. Cat 5
• B. Cat 5e
• C. Cat 6
• D. Cat 6a

Answer: A

NEW QUESTION 15
An end user reports that the time and date on a desktop resets after shutdown, and subsequently, the device reboots. The next day, the desktop does not load the OS and is stuck at a black screen with the following message:

Which of the following would be the BEST action to take next?

• A. Change the motherboard.
• B. Reseat the motherboard power connections.
• C. Replace the CMOS battery.
• D. Restore the BIOS to factory default settings.

Answer: C

NEW QUESTION 16
......