Refined H12-211 Dumps Questions 2021

It is more faster and easier to pass the H12-211 Exam Dumps by using H12-211 Dumps Questions. Immediate access to the H12-211 Dumps Questions and find the same core area H12-211 Dumps Questions with professionally verified answers, then PASS your exam with a high score now.

HUAWEI H12-211 Free Dumps Questions Online, Read and Test Now.

NEW QUESTION 1
<R2>debugging rip 1
Sep 13 2013 11:07:20.974.1-05:13 R2 RIP/7/DBG: 6: 13414: RIP 1: Receiving v1 response
on
GigabitEthernet0/0/0 from 10.0.12.1 with 1 RTE
Sep 13 2013 11:07:20.974.2-05:13 R2 RIP/7/DBG: 6: 13465: RIP 1: Receive response
from 10.0.12.1 on GigabitEthernet0/0/0
Sep 13 2013 11:07:20.974.3-05:13 R2 RIP/7/DBG: 6: 13476: Packet: Version 1, Cmd
response, Length 24
Sep 13 2013 11:07:20.974.4-05:13 R2 RIP/7/DBG: 6: 13527: Dest 1.0.0.0, Cost 1
Sep 13 2013 11:07:20.974.5-05:13 R2 RIP/7/DBG: 6: 2688: RIP 1: Ignoring packet. This
version is notconfigured.
Refer to the debug output. Following configuration of R2, the administrator discovers that the behavior is not asexpected and performs debugging. Based on the output from the debug, what is the source of the problem?

  • A. R2 has configured an ACL to block the route to network 1.0.0.0
  • B. R2 has enabled split horizon.
  • C. R1 is using authentication, however R2 is not.
  • D. R2 is operating using RIPv2, while R1 is using RIPv1.

Answer: D

NEW QUESTION 2
Refer to the graphic. Which statements correctly explains the forwarding behavior between RTA and RTE?(Choose two)

  • A. When the network uses OSPF, data will be forwarded along the path via S1/0/0
  • B. When the network uses RIPv2, data will be forwarded along the path via S1/0/0.
  • C. When the network uses OSPF, data will be forwarded along the path from via E0/0/1.
  • D. When the network uses RIPv2, data will be forwarded along the path via S2/0/0.

Answer: BC

NEW QUESTION 3
In a small network suppporting IPv6, a network administrator wishes implement RIPng. Which of the followingcommands should be used to enable this protocol?

  • A. [RTA-GigabitEthernet0/0/0]ripng 1 enable
  • B. [RTA]ripng 1 enable
  • C. <RTA>ripng 1 enable
  • D. [RTA-ripng-1]ripng 1 enable

Answer: A

NEW QUESTION 4
In a network supporting IPv6, OSPF no longer supports which feature?

  • A. multiple areas
  • B. Router-ID
  • C. authentication
  • D. multicast updates

Answer: C

NEW QUESTION 5
What is the function of the “ip address ppp-negotiate” command?

  • A. Enables the function of requesting for an IP address from the peer device.
  • B. Enables the function of accepting the request for an IP address from the remote device.
  • C. Enables the function of statically allocating IP addresses to the peer.
  • D. None of the above

Answer: A

NEW QUESTION 6
Host A has been connected to switch A and configured with an IP address. When Host A initially forwards aframe, what action will be taken by Switch A?

  • A. Switch A will drop this frame.
  • B. Switch A will attempt to flood the frame to all ports except for the G0/0/1 interface.
  • C. Switch A will forward the frame via ports G0/0/1, G0/0/2 and G0/0/3.
  • D. Switch will receive this frame before returning the frame to G0/0/1.

Answer: B

NEW QUESTION 7
To establish multiple PPP point-to-point connections in the Ethernet network, a PPPoE server establishesconnections with multiple PPPoE clients on one Ethernet port. How does PPPoE differentiate between eachconnection?

  • A. MAC address.
  • B. IP address and MAC address
  • C. MAC address and ppp-id
  • D. MAC address and session-id

Answer: D

NEW QUESTION 8
Refer to the graphic. In order to improve security, the two hosts use IPsec VPN to transmit data. Which IPsecmode and protocol can be used to hide the host’s IP address?(Choose two).

  • A. AH
  • B. transport mode
  • C. tunnel mode
  • D. ESP

Answer: CD

NEW QUESTION 9
A router has learned two routes for the same network with the same prefix. One route has been learned viaOSPF with a metric of 4882, while the other route has been learned via RIPv2 with a metric of 4. Which route(s) will be found in the routing table?

  • A. The RIPv2 route.
  • B. The OSPF and RIPv2 routes.
  • C. The OSPF route.
  • D. Neither of these routes will be found in the routing table.

Answer: C

NEW QUESTION 10
[RTA-GigabitEthernet0/0/0]nat outbound 2000 address-group 1
Refer to the configuration output. What does the value “2000” refer to?

  • A. It represents the ACL number.
  • B. It represents the NAT number.
  • C. It represents the translated port number.
  • D. It represents the number of bytes that can be translated before the address is returned to the public addresspool.

Answer: A

NEW QUESTION 11
A user can view the information for the RIP protocol on a router. What does “Age time” in the returned result ofthe command mean?

  • A. The interval of updating an RIP packet
  • B. The aging time of an RIP route
  • C. The suppression time of an RIP route
  • D. The time spent on switching between RIP routes

Answer: B

NEW QUESTION 12
A layer 2 LAN switch generates CAM table entries according to the ( ) of the received frame.

  • A. Source MAC address
  • B. Destination MAC address
  • C. Source IP address
  • D. Destination IP address

Answer: A

NEW QUESTION 13
Which of the following types can ICMP packets be classified into?(Choose two)

  • A. ICMP transport packet
  • B. ICMP error reporting packet
  • C. ICMP query packet
  • D. ICMP application packet

Answer: BC

NEW QUESTION 14
Refer to the graphic. The network administrator wishes to deny Host A access to the HTTP server but allowaccess to all other servers. Which of the following ACL rules will achieve this?

  • A. Rule deny tcp source 10.1.1.1 0 destination 202.100.1.12 0.0.0.0 destination-port eq 21
  • B. Rule deny tcp source 10.1.1.1 0 destination 202.100.1.12 0.0.0.0 destination-port eq 80
  • C. Rule deny udp source 10.1.1.1 0 destination 202.100.1.12 0.0.0.0 destination-port eq 21
  • D. Rule deny udp source 10.1.1.1 0 destination 202.100.1.12 0.0.0.0 destination-port eq 80

Answer: B

NEW QUESTION 15
UDP is connectionless oriented, which of the following must be used in order to ensure reliability?

  • A. Internet Protocol
  • B. Application Layer Protocol
  • C. Network Layer Protocol
  • D. Transmission Control Protocol

Answer: B

NEW QUESTION 16
Which of the following statements are correct?(Choose two)

  • A. A single collision domain exists between RTA and SWC.
  • B. A single broadcast domain exists between SWA and SWB.
  • C. A single collision domain exists between SWA and SWC.
  • D. A single broadcast domain exists between SWA and SWC.

Answer: CD

NEW QUESTION 17
Which of the following storage devices is used to store the startup configuration files in a router?
<choice ident="A">
<choice ident="B">
<choice ident="C">
<choice ident="D">

  • A. SDRAM
  • B. NVRAM
  • C. Flash
  • D. BootROM

Answer: B

100% Valid and Newest Version H12-211 Questions & Answers shared by Surepassexam, Get Full Dumps HERE: https://www.surepassexam.com/H12-211-exam-dumps.html (New 233 Q&As)